Leak Alarm Relay

Leak Alarm Relay OJ Electronics is a global supplier of thermostats, power controls, HVAC supplies and much more

 

Leak and Humidity Alarm Relay
 

NVP is an electronic unit capable of detecting moisture and water leakage, and is designed to protect installations and materials against condensation and bursting water pipes.
NVP is a safe and reliable alarm system, developed for use in both large and small installations where there is a need for early warning of condensation or pipe bursts. NVP has proved a success in many homes and offices. It is used in the building trade to monitor attics and roof voids in order to keep roof leak damage to a minimum. It is also fitted in HVAC installations to monitor condensation in cooled ceilings as well as pipe bursts.

NVP was designed to provide customers with an advantageous combination of high quality, reliability and low life cycle costs.

  • For use in both large and small installations
  • Can also be used to monitor attics and roof voids
  • Can be fitted to HVAC installations to monitor condensation

 

 

 

 

Product
Download
FAQ
  • Why does the red LED light up the NVP, when there is no moisture on the sensor?

    Reply

    The alarm is activated in two ways:

    • Sensor resistance to high - <900 kOhm (sensor loop interrupted)
    • Sensor resistance to low (Max: <570 kOhm Min: <50 kOhm)
  • Why is the alarm still activated on my NVP, when the sensor isn't wet any more?

    Reply

    Contents of electrically conductive materials ( eg. rust, minerals, glycol) could be left behind on the sensor as it drys. Please change sensor.

  • I need an open circuit in case of leak or power outage. Which terminals do I use?

    Reply

    Connection between terminal 5 and 7 is opened in case of an alarm.

  • What is the maximum sensor length?

    Reply

    Sensor + wire combined can be >50 m. Please do not install near high power cables!

  • There is no interuption in the NVPF, cables or junctions, but the alarm is on. What causes the problem?

    Reply

    If the resistance in the sensor loop is to high (>900 kOhm), please check if termination resistor (680 kOhm) is connected correctly. Please see "How do I connect sensor to relay"

  • How connect a sensor to a relay?

    Reply

Наша

торговая марка
Создание Ноу-хау

Создание Ноу-хау: Мы используем наши знания и опыт, чтобы найти правильное решение.

Новости

и события
Новости и события

Будьте в курсе о последних новостях в компании OJ Electronics.

Экономия

энергии
Экономия энергии

Интеллектуальные системы управления создают максимальный комфорт при низком потреблением энергии.

Свяжитесь с

OJ Electronics
Свяжитесь с OJ Electronics

Диалог и тесное сотрудничество -кратчайший путь к идеальному решению всех проблем.